Aastra Telecom 41-001343-02 User Manual
Operational Features
5-54
41-001343-02 REV04 – 05.2014
Configuring the SIP Local Dial Plan, Dial Plan Terminator, and Digit Timeout
Use the following procedures to configure the SIP Local Dial Plan using the configuration files or the Aastra Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
Aastra Web UI
1.
Click on Basic Settings-> Preferences->General.
2.
In the "Local Dial Plan" field, enter a valid local dial plan (up to 512 alphanumeric characters) for the IP phone. Default is X+#|XX+*. Enter pre-
pended digits or a “;”to present a secondary dial tone if required.
pended digits or a “;”to present a secondary dial tone if required.
Note:
If a User enters a dial plan longer than 512 characters, or a parsing error occurs, the phone uses the default dial plan of “x+#|xx+*”.
If a User enters a dial plan longer than 512 characters, or a parsing error occurs, the phone uses the default dial plan of “x+#|xx+*”.
3.
Enable the "Send Dial Plan Terminator" field by checking the check box. (Disable this field by unchecking the box). Default is disabled.
4.
In the "Digit Timeout (in seconds)" field, enter a timeout value. This is the length of time, in seconds, he phone waits before dialing. Default
is 4 seconds.
is 4 seconds.
5.
Click Save Settings to save your changes.