Aastra Telecom 41-001343-02 User Manual

41-001343-02 REV04 – 05.2014

Parameter – 
sip lineN autodial timeout

(N is a line number from 1 to 9)

Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg

On a per-line basis, this parameter specifies the time, in seconds, that the phone waits 
to dial a pre-configured number after the handset is lifted from the IP phone cradle. 

If this parameter is set to 0 (hotline), the phone immediately dials a pre-configured 
number when you lift the handset. If this parameter is set to a value greater than 0, the 
phone waits the specified number of seconds before dialing the pre-configured 
number (warmline) when you lift the handset. 

Default is 0 (hotline). 

Integer

0

0-120

sip line1 autodial timeout: 30

Parameter – 
sip lineN vmail

(N is a line number from 1 to 9)

Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg

Use this parameter in the <mac>.cfg file to configure the phone to dial a specific 
number to access an existing voicemail account on a Service Provider’s server. The user 
then follows the voicemail instructions for listening to voicemails.

Note:
The phone must have a registered voicemail account from a server for this feature to be 
enabled. When no registered voicemail accounts are registered to the phone, the dis-
play shows "List Empty".

The phone displays up to 99 voicemails for an account even if the number of voicemails 
exceeds the limit.
Registered account numbers/URIs that exceed the length of the screen, either with or 
without the voicemail icon and the message count, are truncated with an ellipse char-
acter at the end of the number/URI string.

String

Not Applicable

0-99

sip line1 vmail: *97

Note:
In the above example, the user would dial *97 to access the voicemail account.