Adtran 624 User Manual

Total Access 600 Series System Manual

Section 4  User Interface Guide

61200624L1-1B

© 2004 ADTRAN, Inc.

53

Sets 

 to 

 or 

to allow or block telnet access to the unit. The factory default value for this 

parameter is

.

Set up the Telnet authentication method from this menu. The choices are 

, 

, 

, and 

. 

 indicates that the unit will try Local Password 

Authentication first, and if that fails, it will try Radius Authentication. 

 indicates that the unit 

will try Radius authentication first, and if that fails, it will try Local Password authentication. The default is 

 

.

Defines the TCP port number used when establishing a Telnet session. Normal Telnet port is 23. Enter a 
customized port number if desired. Make certain the Telnet program you use is configured for the same 
port number (if using a customized port number).

Add Telnet users and control the Telnet access conditions through this menu.

Display the index number of the Telnet users. Up to four users can be configured for access to the 
unit. Each user can be assigned a security level and idle time.

The name is a text string of the user name for this session. The factory default is 

 in the 

 field.You must enter a username in this field (up to 15 characters) because the Telnet entry is 

not activated until it is assigned a valid username. Editing the 

 default to be blank is 

allowed for a single Telnet entry; duplicate usernames are not allowed. During an active Telnet 
session the 

 is displayed in the Telnet Information field located at the bottom of the menu 

screen.

When the authenticating method is 

, or 

, this text string is used for 

the password. You can enter up to 30 characters in this field. The factory default is no entry in this 
field.

This sets the amount of time in minutes you can be idle before you are automatically logged off. The 
factory default is 

. The range is 

.

This is the security level granted to the user. Table 3 on page 54 gives a brief description of each 
level. The factory default is 

.