Panasonic KX-TVS80 User Manual

148

SYSTEM MAINTENANCE AND TROUBLESHOOTING

This command is used to display the circuit condition every 1.5 s. The command can be turned 
off by entering [\]. 

The following circuit conditions may be displayed.

This command is used to display the DTMF tones the VPS receives and sends.

In addition to the DTMF tones the following are displayed — the Incoming Call Service (Voice 
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods 
that the ports are enabled.

Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default 
setting for this mode for all ports is "OFF."

To change the mode from "PUTD" to "OFF," Type PUTD again. 

To set the mode for only 1 port, Type PUTD and the port number.

"Ready"

"Incoming Call Service"

"Outgoing Call Service"

"DSP Reset Processing"

"PT connect Processing"

"Error/Not Exist"

: Possible to serve

: Processing arrival service

: Processing sending service

: Processing DSP reset disposition

: Processing PT connect disposition

: DSP Card is not loaded

$ LMON
CO No.:
           1:      Ready
           2:      Ready

Status

$ PUTD
          Target Port : * *
$

$ PUTD
         Target Port : 00
  Don't leave enabled after troubleshooting
$
        Note:  "*" means "enable" for the port
                   "0" means "disable" for the port