Panasonic KX-TG7102E User Manual

–

 4 

–

5

What kind of power outlet 
should I connect the AC 
adaptor to?

Connect the AC adaptor to a 220–240 V outlet. 

Why is w flashing?

L

The handset is too far from the base unit. Move closer.

L

The AC adaptor is not connected. Check the 
connections.

L

You are using the handset or base unit in an area with 
high electrical interference. Place the handset and base 
unit away from interference sources, such as antennas 
and mobile phones.

L

The handset is not registered to the base unit. Register it.

{j

/OK} i “

” i {>} i 

” i {>} i “

” i 

{>}

 i Press and hold {x} on the base unit for about 3 

seconds, until the registration tone sounds. i Wait until 
“

” is displayed. i Enter the base unit 

PIN (default: “

”). i {j/OK}

Why is the handset display 
blank?

The handset is not turned on. To turn the power on, press 
{ih}

 for about 1 second.

What should I do when the 
handset does not turn on?

L

Make sure that the batteries are installed correctly. 

L

Fully charge the batteries.

L

Clean the charge contacts and charge again.

How long should I charge new 
batteries?

Charge the batteries for about 7 hours.

How long is the battery 
operating time? 

When you are using fully-charged Ni-MH batteries 
(included batteries);
In continuous use: 17 hours max.
In continuous standby mode: 180 hours max.
L

It is normal for batteries not to reach full capacity at the 
initial charge. Maximum battery performance is reached 
after a few complete cycles of charge/discharge (use).

L

Actual battery performance depends on a combination of 
how often the handset is in use and how often it is not in 
use (standby).

Can I keep the handset on the 
base unit or charger when I 
am not using it?

L

Even after the handset is fully charged, the handset can 
be left on the base unit or charger without any ill effect on 
the batteries.

TG7100_7120E(e)_QG.fm  Page 4  Wednesday, July 5, 2006  10:18 AM