Panasonic KX-TG2503S User Manual

Page of 8
Getting Started
Section 1
Selecting the ringer volume
The TALK indicator light must be off.
To select HIGH (preset) or LOW,
press 
Ñ
or 
Ö
.
Each time you press 
Ñ
or 
Ö
, the ringer volume will
change and the selected volume will ring.
To turn the ringer OFF,
press and hold 
Ö
until 2 beeps sound.
To turn the ringer ON,
press 
Ñ
.
The ringer will sound at the HIGH level.
•When you replace the battery, the selected ringer
volume setting will return to the factory set.
To redial the last number dialed
Press 
(TALK)
\
(REDIAL)
.
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
Press 
Ñ
or 
Ö
while talking.
•Each time you press 
Ñ
or 
Ö
, the volume
level will change.
If noise interferes with the
conversation
Press 
(CH)
to select a clearer channel or move
closer to the base unit.
1-E Wall Mounting
If the handset is off the base unit,
press 
(TALK)
.
•You can also answer a call by pressing any dialing
button 
(0)
to 
(9)
(*)
or 
(#)
(— Any Key Talk).
OR
If on the base unit, just lift up. 
2-B Answering Calls
2-A Making Calls
1
Press 
(TALK)
.
•The TALK indicator lights.
•If an alarm tone sounds, see 6-F.
2
Dial a phone number.
3
To hang up, press 
(TALK)
or place
the handset on the base unit.
This unit can be mounted on a wall phone plate.
1
Adjust the angle of the cradle:
#Slide the lock switch
to “RELEASE”.
$Rotate the cradle
90° until it faces
straight up.
%Slide the lock switch
to “LOCK” with the
cradle facing straight
up.
2
Connect the 
AC adaptor.
3
#Tuck the telephone line cord inside the wall
mounting adaptor.
$Connect the telephone line cord to the unit.
%Install the adaptor by pushing it in the
direction of the arrow.
•The word “UP” should face upward.
4
Connect the 
telephone line 
cord. Mount the 
unit, then slide 
down.
•Raise the antennas.
Section 2
Making/Answering Calls
2
(REDIAL)
TALK Indicator
(TALK)
(CH)
,
1
3
Back Side
Back Side
2
To Power 
Outlet
1
2
3
Lighted handset keypad
The handset dialing buttons will light
when you press a button or lift the
handset off the base unit, and flash
when a call is received. The lights will
go out a few seconds after pressing a
button, lifting the handset or answering
a call.
• For best operating performance, see
section 6-D.
You can hang the handset on your belt or
pocket using the belt clip.
To attach the belt clip
To remove the belt clip
1-D Belt Clip