Panasonic KX-TCD400AL User Manual

3

Attached to this apparatus is an approval label. This label is evidence that it is a 
“Permitted Attachment” which has been authorised to be connected to your telephone 
service.
Conditions relating to connection and operation of this Permitted Attachment are 
contained in Telecommunications General By-Law 220 (5).

You are authorised to install this Permitted Attachment yourself by plugging it into the 
line socket of any regular telephone. You may connect it in place of your existing 
telephone or to any spare telephone socket installed in your premises.

To disconnect your existing telephone you must first remove its plug from the line socket. 
You can then insert the plug of your Permitted Attachment into the socket and use your 
equipment.

If the plug of your existing telephone cannot be readily removed, you will have to remove 
the screw securing it. To do this proceed as follows:

1. Loosen screw “A” sufficiently to remove the socket cover. (See Fig. 1.)

2. Remove screw “B” and withdraw the plug. (See Fig. 2.)

3. Replace screw “B”. (See Fig. 3.) Ensure that it screws completely into the socket recess. 

(If the screw is too long, increase the hole depth or replace the screw with one 5 mm 

shorter.)

4. Replace socket cover and tighten screw “A”. (See Fig. 4.)

SOCKET

SCREW “A”

PLUG

Fig. 1

TELEPHONE CORD 
Connect to the PLUG 
as shown in Fig. 1.

(                                       )

SCREW 
 “B”

Fig. 2

SCREW 
“B”

Fig. 3

SOCKET

SCREW “A”

Fig. 4

TCD400AL_e.book  Page 3  Wednesday, August 20, 2003  6:29 PM