Panasonic DBS 824 User Manual

Auto Set Relocation

System Features

1-8

DBS 824-3.0/3.2-700

Revised April 2000

• When one auto mode is turned on, the mode cannot be reset by the DAY/

NIGHT1/NIGHT2, NIGHT key or NIGHT2 key until 3 minutes after the 
auto mode is activated. (When both auto modes are set, the mode keys 
cannot be used.)

• If mode keys are not assigned, the access codes #520 (DAY/NIGHT1/

NIGHT2 toggle), #521 (Day), #522 (Night1) and #523 (Night2) can be 
used instead.

(CPC-S and CPC-M)

Auto Set Relocation can be used to relocate the program settings of one 
extension to another extension. 

Auto Set Relocation is commonly used when extension users want to trade 
work areas. For example, if Extensions “A” and “B” are going to switch 
office locations, Auto Set Relocation enables them to switch telephone 
settings without re-programming.

Before a phone can be relocated, it must be assigned an Auto Set Relocation 
code. See “Related Programming” for the program address used to set up the 
Auto Set Relocation Code.

The following example illustrates how the program settings for extensions 
200 and 300 could be switched. 

1.  At extension 200, pick up the handset.

2. Press 

“#10.”

3.  Dial extension number 300.

4.  Enter the four-digit auto set relocation code assigned to extension 300.

5.  Replace the handset.

• All programmed extension features, TRS, and LCR settings from 200 

are transferred to 300.