Panasonic KX-DT343 User Manual

Page of 24
Important Information
18                                                                                                Document Version 2009-03
Important Information
When using KX-DT300 series DPTs, keep the following 
conditions in mind.
• If you are having problems making calls, unplug the extension line and 
connect a known working telephone. If the known working telephone 
operates properly, have the defective telephone repaired by an 
authorized Panasonic factory service center. If the known working 
telephone does not operate properly, check the PBX and the internal 
extension wiring.
• Wipe the unit with a soft cloth. Do not clean the unit with abrasive 
powders or with chemical agents such as benzene or thinner.
• Use only the correct Panasonic handset.
• Do not disassemble this unit. Dangerous electrical shock could result. 
The unit must only be disassembled and repaired by qualified service 
technicians.
• If damage to the unit exposes any internal parts, immediately disconnect 
the cable or cord. 
• Never attempt to insert wires, pins, etc. into the vents or other holes of 
this unit.
Take special care to follow the safety suggestions listed below. 
Installation
Environment
1) Do not use this unit near water, for example, near a bathtub, washbowl 
or sink. Damp basements should also be avoided.
2) Keep the unit away from heating appliances and devices that generate 
electrical noise, such as fluorescent lamps, motors, and televisions. 
These noise sources can interfere with the performance of the unit. It 
also should not be placed in rooms where the temperature is less than 
5 °C (41 °F) or greater than 40 °C (104 °F).
 
Allow 10 cm (3-15/16 in) clearance around the unit for proper 
ventilation.
Placement 
1) Do not place heavy objects on top of this unit.
2) Care should be taken so that objects do not fall onto, and liquids are 
not spilled into, the unit. Do not subject this unit to excessive smoke, 
dust, moisture, mechanical vibration, shock, or direct sunlight. 
3) Place the unit on a flat surface.