Panasonic 524X07801B User Manual

Page of 334
Section 700 - Operation
Chapter 3. System Features
576-13-700
DBS 576 (USA), Revised 6/11/98
 35
Considerations
The DID Trunk card supports 1 to 4-digit dial-pulse (10 pps) or Dual Tone Multifrequency 
(DTMF) signaling. 
DID numbers must be between 0 and 9999.
CO Trunk Interface - Ground Start
Ground start trunks are supported in the System with the VB-44511 Loop Start/Ground Start trunk 
interface. Each card supplies 8 circuits that can be individually configured for either loop start or 
ground start operation.
Ground start trunks are useful in preventing call collision.
Hardware Requirements
When ground start trunks are used, the -48V power supply is required.
Related Programming
N/A
Considerations
N/A
CO Trunk Interface - ISDN BRI
The System supports ISDN BRI with the VB-44530 ISDN BRI interface unit. The VB-44530 is a T-
Point ISDN-BRI that supports 2 B (bearer) channels and 1 D (data) channel (2B + D; 192kbps). This 
unit connects to an ISDN Data Service Unit (DSU). Point-to-point and point-to-multi operations are 
selectable.
The ISDN-BRI supports enblock setting and enblock setting at the sub-address.
Hardware Requirements
N/A
Related Programming
N/A
Considerations
A DSU is required (not available from Panasonic).
CO Trunk Interface - ISDN-PRI
The System supports ISDN-PRI with the VB-44540 ISDN PRI Interface unit. The VB-44540 is a T/S-
Point ISDN-PRI that supports 23 B (bearer) channels and 1 D (data) channel (23B + D; 1544kbps). 
This unit connects to an ISDN DSU.
Up to 3 units may be installed in a cabinet if you use full channel (23B + D or 24 B). A maximum of 
18 units may be utilized in a fully equipped system. When all 24 channels on a unit are utilized, 3 slot 
positions are required. 
Hardware Requirements
N/A