Nortel Networks 1000E User Manual
Configuring a Small System Controller
Page 227 of 488
Communication Server 1000E
Installation and Configuration
Procedure 56
Installing an SSC NTM400 Software daughterboard and NTDK57
(NT_REM) remote security device
Installing an SSC NTM400 Software daughterboard and NTDK57
(NT_REM) remote security device
1
Unpack the NTDK20 SSC, and set it aside on a clean surface.
2
Install the NTM400 Software daughterboard in the appropriate connector,
as shown in Figure 84 on
as shown in Figure 84 on
.
3
Press firmly on the standoffs to ensure that the NTM400 Software
daughterboard is secured to the SSC.
daughterboard is secured to the SSC.
4
Insert the NTDK57 (NT_REM) Security Device with NT_REM facing out.
See Figure 84 on
See Figure 84 on
.
5
Repeat procedure for each SSC.
End of Procedure
Adding a 100BaseT daughterboard (dual port)
Follow Procedure 57 to add a 100BaseT daughterboard (dual port) to an SSC.
Procedure 57
Adding a 100BaseT daughterboard (dual port) to an SSC
Adding a 100BaseT daughterboard (dual port) to an SSC
1
Unpack the 100BaseT daughterboard (dual port) and the NTDU0606
cable.
cable.
2
Using the two NTDU0606 CAT5 Ethernet cables provided:
CAUTION WITH ESDS DEVICES
Static electricity can damage circuit cards. Wear an
antistatic wrist strap when handling circuit cards or any of
their components.
antistatic wrist strap when handling circuit cards or any of
their components.
CAUTION WITH ESDS DEVICES
Static electricity can damage circuit cards. Wear an
antistatic wrist strap when handling circuit cards or any of
their components.
antistatic wrist strap when handling circuit cards or any of
their components.