Nortel Networks 1000E User Manual
Installing software on an MG 1000T Small System Controller
Page 245 of 488
Communication Server 1000E
Installation and Configuration
Installing software on an SSC
Follow Procedure 60 to power up a new system installation in preparation for
loading the software.
loading the software.
Procedure 60
Installing software on an SSC
Installing software on an SSC
1
Test the power outlet.
Make sure that the correct voltage is present before you plug the power
cord into the outlet. The source must match the label at the back of the
equipment.
Make sure that the correct voltage is present before you plug the power
cord into the outlet. The source must match the label at the back of the
equipment.
2
Connect the power cord from the power connectors at the back of the
Media Gateway to an AC power source. See Figure 86 on
Media Gateway to an AC power source. See Figure 86 on
.
IMPORTANT!
Before proceeding, ensure that the required hardware is correctly
installed and that all connections are secure.
installed and that all connections are secure.