Nortel Networks 1000E User Manual

 Connecting a Terminal Server

553-3041-210 Standard 4.00 September 2007

Enable autoconnect for the port. Enter the command:

DEFINE PORT xx AUTOCONNECT ENABLED

Where:

xx

 = port number

Enable autodedicate for the port. Enter the command:

DEFINE PORT xx AUTODEDICATED ENABLED

Where:

xx

 = port number

Define a user name for the port. Enter the command:

DEFINE PORT xx USERNAME “ptyxx”

Where:

xx

 = port number

ptyxx

 = User Name is the pty port set during Call Server configuration 

for rlogin connection. The pty port is set using LD 17. For example, in LD 
17, configure TTY 2 as pty. The port # username on Terminal Server 
becomes "pty2", not "PTY2" or "pty02".

Note 1: Ignore the following MRV information message during using 
DEFINE command.  "In-Reach -729- Parameter cannot be modified by a 
set command". This is informational only that you must use DEFINE and 
not the more general SET command. It is not an error. 

Note 2: The quotation marks (““) are also required around "PTYxx"

Log out of the port. Enter the command:

LOGOUT PORT xx

Where:

xx

 = port number