Nortel Networks 1000E User Manual
Page 390 of 488
Installing Line cards and cross-connecting telephones
553-3041-210 Standard 4.00 September 2007
Procedure 100
Connecting an off-premise telephone
Connecting an off-premise telephone
1
Install the NTAK92BA Off-Premise Protection Module on the wall using
four #10 1/2-in (minimum) screws.
four #10 1/2-in (minimum) screws.
2
Connect a #6 AWG from the grounding lug at the bottom of the
NTAK92AA Off-Premise Protection Module to the system ground. Refer
to Figure 143 on
NTAK92AA Off-Premise Protection Module to the system ground. Refer
to Figure 143 on
.
3
Connect two NTAK9204 cables (one from connector J1 and one from
connector J2) from the protection module to the cross-connect terminal.
connector J2) from the protection module to the cross-connect terminal.
4
Terminate the cables as shown in Figure 141 on
5
Cross-connect the J1 cable to the Tip and Ring connections coming from
the Line card.
the Line card.
6
Cross-connect the J2 cable to the off-premise telephone.
7
Install the regulatory label provided with the Off-Premise Protection
Module on the inside right-hand wall of the Media Gateway.
Module on the inside right-hand wall of the Media Gateway.
8
Install the Line card in its assigned position.
9
Activate the telephone.
DANGER OF ELECTRIC SHOCK
If connecting to a message-waiting Line card, unseat the
card from its assigned slot before continuing with the
next step.
card from its assigned slot before continuing with the
next step.