Vertical Communications DX-80TM User Manual

Page 42

P7292 DETUG 09/01

4.2.  To program a feature code, press [ftr].

FTR CODE:_

 bksp save chg

4.2.1. Press the 

!

 button.

4.2.2. Input the feature code 

6/

 (for CID Table review) and

then press [save].

5.  Continue programming other Flexible Feature Buttons or lift/replace

the handset to exit this programming.

!9/

All Digital Speakerphones have a standard 2.5 millimeter headset jack.
When Headset Mode is selected (either by pressing a preprogrammed

headset feature key or dialing the Headset Mode code), the 

 button is

used to activate/deactivate the headset.

When you press the 

 button, Headset Mode active and the extension

status changes to an off-hook condition. When you press the 

 button

again, the extension status returns to idle, disconnecting any call in
progress.

1.  While the telephone is idle, press 

!9/

 or press the Flexible

Feature button designated as HEADSET MODE (if available). The
display indicates the new status:

HEADSET ENABLED

1.  While the telephone is idle, press 

!*9/

 or press the Flexible

Feature button programmed with the Headset Mode code. The display
indicates the new status:

HEADSET DISABLED

1.  While the telephone is idle, press 

, a DSS button, or outside line

button. The 

 button LED flashes to indicate that the headset is

active. You hear Intercom dial tone, outside line dial tone, or Intercom

ring-back tone, depending on the function invoked.

2.  Press 

 again to disconnect the current call.