Chamberlain EL25 User Manual
Page 8
System Feedback / Responses (Beeps)
2 Short Beeps:
Programming step was valid.
3 Short Beeps:
Programming mode was exited.
1 Long Beep:
Input was not valid.
2 Long Beeps:
Duplicate entry code was entered.
3 Long Beeps:
Memory is full.
4 Long Beeps:
Unit has reset or is powering up.
Busy Signal:
Line is busy or Do Not Disturb feature is in effect.
The EL25 emits various audio tones to respond to input and to indicate certain conditions.
1 Short Beep:
Key was pressed on the unit's keypad.
1 Beep:
Talk time for a visitor call is lapsing and the unit will beep once per second for the
last 10 seconds unless the talk time is extended.
Ring Back:
The unit is ringing the building.
10 Short Beeps:
The unit has granted access.
Silence:
The keypad has struck out, the unit is being programmed from
another source, or an alarm condition exists.
5 Short Beeps:
Gate is closing by command.
10 Short Beeps
Gate is opening by command.
1 Lift the receiver and press
Enters direct command mode
Enters direct command mode for unit three
The unit is now ready to allow direct commands only!
(NPBI / Single Family Residence ONLY)
1A If multiple EL25 units are sharing the same phone line, then a Unit ID Code (1-7) will need
to be entered at this time.
Example 1:
Example 2:
You can send commands directly to the EL25 from your phone without being in programming mode.
This feature is only available for a single-family residence or a manager is sharing a phone line
with the EL25.
This feature is only available for a single-family residence or a manager is sharing a phone line
with the EL25.
Programming Single Unit Over
view
Programming Single Unit Over
view
Programming Responses:
Direct Command Responses:
Other Responses:
To Enter a Direct Command from a Residence Phone:
Sending Direct Commands from the Resident's Phone