AT&T CL82509 User Manual
3
Battery installation & charging
Install the battery as shown below. Once you have installed the battery, the
screen indicates the battery status (see table below). If necessary, place the
handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the charger when not in use. The battery is
fully charged after 16 hours of continuous charging. See the table on the
Technical specifications page of the user’s manual for battery
operating times.
If the screen is blank, you need to charge the handset without interruption
for at least 10 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows LOW BATTERY and the
backlight is off until you have charged the battery without interruption for at
least one hour. The following table summarizes the battery charge indicators
and actions take.
screen indicates the battery status (see table below). If necessary, place the
handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the charger when not in use. The battery is
fully charged after 16 hours of continuous charging. See the table on the
Technical specifications page of the user’s manual for battery
operating times.
If the screen is blank, you need to charge the handset without interruption
for at least 10 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows LOW BATTERY and the
backlight is off until you have charged the battery without interruption for at
least one hour. The following table summarizes the battery charge indicators
and actions take.
Battery indicators
Battery status
Action
The screen is blank.
Battery has no charge and the
handset cannot be used.
handset cannot be used.
Charge without interruption until
the screen shows LOW BATTERY
(at least 10 minutes).
the screen shows LOW BATTERY
(at least 10 minutes).
The screen shows PLACE
IN CHARGER and
flashes.
IN CHARGER and
flashes.
Battery has very little charge
and the handset cannot be used.
and the handset cannot be used.
Charge without interruption until
the screen shows LOW BATTERY
(at least four minutes).
the screen shows LOW BATTERY
(at least four minutes).
The screen shows LOW
BATTERY and flashes.
BATTERY and flashes.
Battery has enough charge to
be used for a short time.
be used for a short time.
Charge until the screen shows
HANDSET X (about one hour).
HANDSET X (about one hour).
The screen shows
HANDSET X.
HANDSET X.
Battery is charged.
To keep the battery charged,
place it in the telephone base or
charger when not in use.
place it in the telephone base or
charger when not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
every minute.
Step 1
Plug the battery securely into the
connector inside the handset battery
compartment, matching the color-coded
label. Insert the supplied battery with the
label THIS SIDE UP facing up as indicated.
connector inside the handset battery
compartment, matching the color-coded
label. Insert the supplied battery with the
label THIS SIDE UP facing up as indicated.
Step 2
Align the cover flat against the
battery compartment, then slide
it upwards until it clicks into
place.
battery compartment, then slide
it upwards until it clicks into
place.