AT&T 1040 User Manual
19
Telephone operation
Basic phone operation
Call waiting
If you subscribe to call waiting service with your
local telephone company, there will be a beep if
there is an incoming call when you are already on
a call on the same line.
1. Press
local telephone company, there will be a beep if
there is an incoming call when you are already on
a call on the same line.
1. Press
[FLASH] to put your current call on hold
and take the new call.
2. Press
[FLASH] anytime to switch back and forth
between calls.
MUTE
During a telephone conversation, press
[MUTE] to
silence the microphone. You will be able to hear the
other party, but the other party will not be able to
hear you until you press
other party, but the other party will not be able to
hear you until you press
[MUTE] again and resume
speaking. Mute is automatically cancelled when you
end a call.
end a call.
When mute is active, the
MUTE light will be on.
NOTE: Switching from handset to speakerphone
or headset, or from speakerphone or headset to
handset, changing lines, and putting a call on hold
also cancel the mute function.
handset, changing lines, and putting a call on hold
also cancel the mute function.
Temporary tone dialing
If you have dial pulse (rotary) service only, you can
temporarily switch dial pulse to touch-tone dialing
during a call by pressing
temporarily switch dial pulse to touch-tone dialing
during a call by pressing
[*TONE].
1. Dial the number.
2. Press and release
2. Press and release
[*TONE]. Buttons pressed after
this send touch-tone signals.
3. After you hang up, the phone automatically
returns to pulse dial mode.