Precor p20 User Manual
Setting Up the Console
19
Event Log
The software is able to detect a variety of events. The event
log holds a maximum of 30 events. After the log reaches 30
events, older events are erased to make room for newer ones.
Note: There is a shortcut for quick access to the Event Log
Note: There is a shortcut for quick access to the Event Log
report. From the Welcome banner, press
Reset (Pause/Reset
on tread consoles)
for five seconds. If there are no events, the
words
STUCK KEY appear and then the console returns to
the Welcome banner.
Each event log entry contains the following information:
Each event log entry contains the following information:
Event number
Odometer value when the event occurred
Hour meter value at the time the event occurred
Current drawn by the motor when the event occurred
(treadmill only)
The following table contains a list of events detectable by the
software.
Table 2. Event log numbers and descriptions
Event
Number
Description of Event
00
Upper PCA memory location event
02
RAM location event
03
EEPROM checksum event
05
Depressed key at power up
09
Lower PCA memory test event
10
Line Frequency out of acceptable range
11
Watchdog (Upper PCA) low voltage power
12
Watchdog (Lower PCA) low voltage power
13
Fan at incorrect speed (version 1 treadmills)
14
Fan fail (Lower PCA)
15
AC input voltage too high
16
AC input voltage too low
20
Too many maximum power requests in one second
21
Too many maximum consecutive power requests