Vidikron Vision 10 User Manual

1.

Turn on your source components.

2.

Plug the female end of the power cord 
into the AC receptacle on the rear of the 
Vision 10/12 (AC 100V ~ 240V).

3.

Connect the other end to your AC power 
source. The power indicator lights blue to 
indicate that the Vision 10/12 is in 
“standby” mode.

4.

Press the ON button on the remote 
control to turn on the projector. The 
power indicator turns off.

5.

After a brief warm-up period (approximately 10 seconds), the Vision 10/12 will start 
projecting.

When the Vision 10/12 is installed upright, you can adjust the projector height or projection 
angle by turning the four adjustable feet on the bottom of the projector; see Figure 4-1. This 
is useful for correcting the angle of projection when the projector is placed on an uneven 
surface or when the screen is at an angle. You can tilt the projector up to five (5) degrees up 
or down by adjusting the feet.

The feet are connected to threaded bolts; turn them clockwise to raise the projector or 
counterclockwise to lower it. 

4

Tilting the projector may cause keystone distortion. To correct this, refer 
to Keystone Correction on page 45.