Vidikron Vision 10 User Manual

• Auto Tune: Auto Tune automatically adjusts settings to optimize computer images. Auto 

Tune can be executed either on command or automatically whenever an incoming RGB 
signal is present. To execute Auto Tune on command, select Execute Auto Tune and press 
ENTER. To enable automatic Auto Tune, select Auto Tune and set it to ON. 

Image Position: To adjust the horizontal and vertical position of the projected image, select 
Image Position from the Image Option menu and press ENTER. 

• H  Position:  Use the up- or down-arrow buttons ( 

 ) to select H Position. Then, use the 

right-arrow button ( 

 ) to shift the image to the right; use the left-arrow button ( 

 ) to 

shift the image to the left. 

• V  Position:  Use the up- or down-arrow buttons ( 

 ) to select V Position. Then, use the 

right-arrow button ( 

 ) to shift the image up; use the left-arrow button ( 

 ) to shift the 

image down.

To restore the default image position, select Reset and press ENTER. Then, press ENTER to 
confirm or EXIT to cancel. 

Over Scan Adjust: Overscan pushes the outside edge of the active picture area of the video 
signal out beyond the edge of the display area. 

Some television programs are produced based on the assumption that older television sets 
may not display the outer edges of the broadcast picture area. Over scan effectively trims 
away these inactive, outer edges and enlarges the remaining portion of the image to fill the 
display area.

Select from 0% to 10% of Overscan, as desired.

For HDTV, DVDs and other video sources, Overscan is generally not necessary or desirable.

SDTV Adjust: To maximize the quality of 480i (composite, S-Video or component) video 
signals, select SDTV Adjust from the Image Option menu and press ENTER. 

• Chroma Enhance: Use Chroma Enhance to add chroma (color information) to the input 

signal, making colors appear more vibrant and saturated. 

• Video On Film: Set Video On Film to ON to repair distortions or abnormalities in a video 

image. 

• Film  Mode:  Use the Film Mode control to smooth out moving images from interlaced 

sources. In most cases, the Vision 10/12 detects the proper “pull-down” rate and vertical 
frequency. However, if your source is jittery and/or tearing you may wish to force a setting 
to ensure stable processing for that source. 

Brightness Enhance: to amplify the bright areas of the image, select Brightness Enhance 
and use the right- or left-arrow button ( 

 or 

 ) to set it to ON. Brightness Enhance can be 

useful for high ambient light environments or when you use the lower Lamp Power setting 
(see below). 

Lamp Power: Select Lamp Power from the Display Color Menu to adjust the lamp output 
level. You can choose to run the lamp as bright as possible (250W; this is the default setting) 
or you can choose the lower setting (200W). Generally, lower lamp output can prolong the 
life of the lamp, but decreases brightness.