Vidikron Vision 65 User Manual

Focus: Finally, rotate the Focus Ring on the anamorphic lens 
to fine-tune the optical focus. 

The Whitney (Prismatic) Anamorphic lens mount kit consists of everything shown in Figure 
3-19. Some components shipped with your projector may differ slightly from what is shown 
in these instructions. 

1.

Use the Pitch/Y-Adjustment Screws and Washers (item #6) to attach the Vertical 
Mounting Brackets (item #5) to the Anamorphic Lens (item #1). 

2.

Place the lens with the brackets installed on top of (or under, if the projector is inverted) 
the Base Plate (item #2), so that the two threaded posts at the bottom of the brackets 
pass through the corresponding slots on the base plate.

3.

Secure the lens assembly to the base plate with the Yaw/Z-Adjustment Knobs and 
Washers (item #4).

 

 

F

O

C

U

S

➤

2   Base Plate

5   Vertical Mounting
     Bracket (2x)

6   Pitch/Y-Adjustment
     Screw, Phillips
     Pan Head, 4-40 x 3/8”
     (4x) and Fender 
     Washer (4x)

4   Yaw/Z-Adjustment
     Knob (2x) and
     Washer (2x)

1    Anamorphic Lens

3   Screw, Phillips
     M6x16mm (2x) and
     1/4” Flat Washer (2x)
     (not shown; secures Base Plate
     to bottom of projector)