Vidikron Vision 150 User Manual

If the status code display on the back of the projector shows one of the following values, you 
have encountered a likely system error requiring the attention of a qualified service 
technician. Acknowledge and clear the error by pressing EXIT twice on the rear-panel 
keypad. Try resetting the projector by powering it off, allowing it to cool and powering it on 
again. Refer to Table 5-2 and contact your dealer if the problem persists. 

The specific code number identifies the source of the error detected, and is particularly useful 
in cases where the projector is far away. For example, the code “27” means the lamp could 
not be turned on.  

12

Software bug. Contact dealer or Vidikron Technical Support. 

13

CRC error in flash ROM. Download new software. 

14

Engineering-only programming is complete. Contact Vidikron, replace TIPM. 

15

Attempting to download code without being in boot mode. 

16

Invalid interrupt. Power off/on. If it persists, contact dealer or Vidikron Technical 
Support. 

17

User forced system to stay in boot mode. 

18

Jumper for programming boot not installed. 

20

Lamp turned on unexpectedly (fault related to ballast). 

21

Lamp airflow low, overheating imminent. 

23

Cannot read valid ballast ID. 

26

Lamp 1 Interlock: lamp door open, lamp not installed. 

27

Can’t turn lamp on. 

28

Lamp turned off unexpectedly. 

29

Lamp ballast overheated.