Vidikron Vision 150 User Manual

3.

Select Locked from the Channel Setup menu and press ENTER to clear the check box. 

Use the Auto Setup feature of the Vision 140/150 as a convenient starting point for 
calibrating the projector DVI input for optimum picture quality. 

Auto Setup is an automated process in which the projector quickly optimizes critical display 
parameters such as size, position and pixel tracking, based on the type of incoming video 
signal. An Auto Setup allows you to quickly get the image “in the ballpark” after which you 
can perform further calibration, if necessary. 

To perform an Auto Setup, do one of the following: 

On the Theater Master Remote Control: Press FUNCS, then AUTO followed by Enter. 
When the Auto Setup completes, press Enter again to keep the new settings. 

On the Projector Rear Keypad: Press AUTO SETUP followed by Enter. When the Auto 
Setup completes, press Enter again to keep the new settings. 

On the VHD Controller Remote Control: Press MENU, then select Service from the Main 
menu. Select Display Device from the Service Menu. Finally, select Configure from the 
Display Device menu, then select Auto Setup.

What an “Auto Setup” Does: Auto Setup sets the following parameters to their default 
values:

•

White Level (Contrast)

•

Black Level (Brightness)

•

Pre-Calibration (Auto Input Level) (off) 

•

Sharpness (Detail) (if video source)

•

Filter

•

Luma  Delay

Clear this check box to unlock the channel

➤

You cannot use Auto Setup with a locked channel; you must unlock it 
first. Refer to Unlocking Channels on page 49.