Vidikron Model 85 User Manual

By default, the Vision 85 is configured for a “floor/front” installation, in which the projector is 
installed upright and in front of the screen. If it is installed behind the screen and/or mounted 
on a ceiling, you must change the picture orientation. To do this:

1.

Select an input OTHER THAN HDMI 1 or HDMI 2 on the VHD Controller. 

2.

Press MENU and enter the Service Menu passcode.

3.

Select Service from the Main Menu. 

4.

Select Display Device from the Service Menu, then select Configure.

5.

Press 

, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation 

method.

 

To focus the projected image, gently rotate the lens 
by hand. 

To enlarge the picture (zoom in), move the zoom tab 
toward the Vidikron logo on the front of the projector. 
To make the picture smaller (zoom out), move the tab 
in the other direction. 

To change the projected image position, use a 9/64” hex driver to shift the lens in the desired 
direction; see Figure 3-19. The vertical lens shift control is at the top of the projector. (The 
tool will automatically center on top of the adjustment nut when inserted into the access 
hole.) 

Zoom
in

Focus

Zoom
out

9/64” Hex Wrench