Leica CM3050 S User Manual
59
Leica CM 3050 S – Cryostat
An electrohydraulic lifting device for individual
working height adjustment is available as an
optional accessory for the CM3050 S cryostat
series.
working height adjustment is available as an
optional accessory for the CM3050 S cryostat
series.
1.1 Designated use
The electrohydraulic height adjustment device
has been designed exclusively for adjustment
of the instrument working level to the individual
height of the user.
It has been designed for use with the Leica cry-
ostat series CM3050 S only and may under no
circumstances be used to lift other instruments
or persons.
Damage resulting from improper use of the
product and/or faulty operation invalidates the
warranty.
Leica will not assume liability for any such dam-
age.
has been designed exclusively for adjustment
of the instrument working level to the individual
height of the user.
It has been designed for use with the Leica cry-
ostat series CM3050 S only and may under no
circumstances be used to lift other instruments
or persons.
Damage resulting from improper use of the
product and/or faulty operation invalidates the
warranty.
Leica will not assume liability for any such dam-
age.
1.2 Standard delivery
Electrohydraulic height adjustment device for
cryostat series CM3050 S, complete outfit, con-
sisting of a U-shaped frame on four height-ad-
justable feet and a two-key control unit.
cryostat series CM3050 S, complete outfit, con-
sisting of a U-shaped frame on four height-ad-
justable feet and a two-key control unit.
The height adjustment device is available in 2
voltages:
voltages:
1. 230 – 240 V / 50 Hz – order no. 0443 26147
2. 230 – 240 V / 50 Hz – order no. 0443 26147
Prior to connecting the height ad-
justment device to mains, check to
make sure that the nominal voltage
and frequency indications on the
device name plate correspond to
the actual mains voltage in your
lab!
justment device to mains, check to
make sure that the nominal voltage
and frequency indications on the
device name plate correspond to
the actual mains voltage in your
lab!
Do not move the height adjustment
device with the Leica CM3050 S in-
stalled on the frame. If the place of
installation needs to be changed,
first take the Leica CM3050 S down
from the height adjustment device
and then move both devices sepa-
rately.
device with the Leica CM3050 S in-
stalled on the frame. If the place of
installation needs to be changed,
first take the Leica CM3050 S down
from the height adjustment device
and then move both devices sepa-
rately.
Never place your feet underneath
the U-frame when lowering the
height adjustment device! Risk of
injury!
the U-frame when lowering the
height adjustment device! Risk of
injury!
Only authorized Leica technical ser-
vice engineers may carry out re-
pairs on both the Leica CM3050 S
and the height adjustment device.
This applies especially to all work
carried out on the hydraulic system
of the height adjustment device.
vice engineers may carry out re-
pairs on both the Leica CM3050 S
and the height adjustment device.
This applies especially to all work
carried out on the hydraulic system
of the height adjustment device.
1.3 Safety instructions
1.
Electrohydraulic height adjustment
Prior to operating the height adjustment device,
make sure to read the present instruction manu-
al. Pay special attention to the following safety
instructions:
make sure to read the present instruction manu-
al. Pay special attention to the following safety
instructions:
9.
Appendix