Sony KP-65WS500 User Manual

Page of 82
Installing and Connecting the Projection TV
22
Model name1[KP-46WT500] Model name2[KP-51WS500] Model name3[KP-57WS500] Model name4[KP-65WS500]
[4-088-847-12]
Connecting Two VCRs for Tape Editing
If you connect two VCRs, you can record from one VCR to the other while 
using your projection TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1
Using AUDIO and VIDEO cables, connect the playback VCR’s Audio 
and Video OUT jacks to the recording VCR’s Audio and Video IN 
jacks.
2
Using AUDIO and VIDEO cables, connect the recording VCR’s 
AUDIO and Video OUT jacks to the projection TV’s AUDIO and 
VIDEO IN jacks. 
Rear of projection TV
VCR (playback)
VCR (recording)
VMC-810S/820S (not supplied)
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
To perform tape editing, set the projection TV to the video input intended 
for playback by pressing TV/VIDEO on the remote control.
You may need to change the video input on your VCR. Consult your 
VCR’s operating manual for instructions.
If your VCRs have an S VIDEO jack: For best picture quality, use an 
S VIDEO connection instead of the yellow video cable on your combined 
A/V cable.
Using an S VIDEO cable, connect the playback VCR’s S VIDEO OUT jack 
to the recording VCR’s S VIDEO IN jack. S VIDEO does not provide audio, 
so audio cables must be connected to provide sound.
You cannot record signals from equipment connected to the Y, P
B
, P
R
 
input.
01COV.book  Page 22  Tuesday, July 30, 2002  3:46 PM