Panasonic PT-50LC14 User Manual

Requires two AA batteries (supplied).

1.  While pressing in on the catch, 

open cover in direction of arrow.

2.  Install the batteries as shown in 

the battery compartment.

 

(Polarity + or - must match the 
markings in the compartment).

3.  Press cover in direction of 

arrow until it snaps shut.

Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote 
control.
Observe the following precautions:

1.  Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2.  Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
3.  Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
4.  Battery replacement is necessary when the remote control acts sporadically or stops operating the projection 

display set.

1. Remote 

Control 

(EUR7627Z20)

2.  Batteries 2 “AA”
3.  RGB Cable  (2 m) 

(LSJA0239-1 or LSJA0443)

(1)  For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life.
(2)  Whenever you remove the batteries, you may need to reset the remote control infrared codes. We 

rec ommend that you record the code on page 76, prior to setting up the remote.

CAUTION

Two AA size