Panasonic PT-DW7000E User Manual
99
ENGLISH
• After 1 500 hours (4 000 hours when Long Life Lamp Units are used) of operating the same lamp, it is
only possible to operate the unit for approximately 10 minutes. Steps 9 to 15 must be completed within
ten minutes.
ten minutes.
1. Turn the power off by following the steps on pages 33 ~ 34, remove the power plug
and confirm that the surroundings of the lamp unit have cooled off.
2. Using a Philips screwdriver, remove
the 7 screws on the lamp unit cover
located on the rear of the projector.
located on the rear of the projector.
3. Remove the lamp unit cover from the
main unit.
4. Use a Phillips screwdriver to loosen
each of the two lamp unit fixing screws
until the screws turn freely. Then hold
the handle of the lamp unit and gently
pull it out from the projector.
until the screws turn freely. Then hold
the handle of the lamp unit and gently
pull it out from the projector.
Caution
The lamp unit will be hot after it has
been used.
been used.
You might get burned if you touch it while it is still
hot.
hot.
5. Install the new lamp unit.
6. Use a Phillips screwdriver to securely tighten the two lamp unit fixing screws for
each lamp unit.
7. Install the lamp unit cover, and then
use a Phillips screwdriver to securely
tighten the lamp unit cover fixing 7
screws.
tighten the lamp unit cover fixing 7
screws.
• Firmly install the lamp unit and lamp
unit cover. If not installed firmly, a
protection circuit will function and the
power will not be turned on.
protection circuit will function and the
power will not be turned on.
Procedure of lamp unit replacement
Lamp unit cover
Fixing screws
Lamp unit
Fixing screws
Handle
Lamp unit
Fixing screws
Lamp unit 2
Lamp unit 1
Lamp unit cover
Fixing screws
Caution
Caution