Panasonic PT-DW7000 User Manual

Page of 12
The main unit is equipped with SERIAL terminals located in its terminal section on the side, and this terminal is
compliant with RS-232C. 
Panasonic Projectors RS-232C Control Specifications
PT-D10000/DW10000 PT-D7700/DW7000  PT-D5600/DW5000 PT-D5500  PT-D3500
Pin assignments and signal names
Communication conditions (Factory setting)
Basic format
Transmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in this
order. Add parameters according to the details of control.
Start
 ID designate
3 command 
characters (3 bytes)
Parameter
 (undefined length)
End
 Two ID  characters 
(2 bytes)
Semicolon
Colon
ZZ, 1 to 64 and 0A to 0Z
STX
C1
C2
C3
:
P1
P2
Pn
ETX
A D
I 1
I 2
;
Attention
Note
D-Sub 9-pin (female), 
external appearance
Serial input terminal 
Pin No. Signal name
TXD
RXD
GND
CTS
RTS
Description
NC
Send data
Receive data
Connected internally
Ground
NC
Connected internally
NC
D-Sub 9-pin (male),
external appearance
Serial output terminal
Pin No. Signal name
RXD
TXD
GND
RTS
CTS
Description
NC
Receive data
Send data
NC
Ground
NC
Connected internally
NC
Signal level
Synchronization method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
RS-232C-compliant
Start-stop synchronization
9 600bps
None
8 bits
1 bit
None
None
 If a wrong command is received, the projector will send an ER401 or ER402 command to the computer. 
 Projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.
 If a command is sent with a projector ID specified, the projector will return answer back only in the
following cases:
If it coincides with the projector ID,
ID specification is ALL and VPS-SYSTEM is the master, or
ID specification is group and Group is the master.
 No command can be sent or received for 10 to 60 seconds after the lamp starts lighting. Try
sending any command after that period has elapsed.
 When sending several commands, be sure to wait for more than 0.5 seconds after receiving a
 response from the projector, and then send the next command.
 When sending commands without parameters, a colon (:) is not necessary.
1