Panasonic PT-L701SDE User Manual

% Select and click Stop Standard IDE/ESDI

Hard Disk Controller or Stop BN-SD
SeriesPCMCIA Disk Controller.

& The screen shown at right will appear. Click

OK to remove the PC card adapter.

(

( Press the eject button of the PC card

adapter and take out the SD memory card.

Note:

B Be sure to follow the removal procedure

correctly. If the correct procedure is not
followed, it may result in damage to the card
or loss of data on the card.

Using the SD memory card in a Macintosh

The accessory PC card adapter can be used to insert the SD memory card
into a Macintosh with a built-in PC (PCMCIA) card slot which is either Type II
or Type III compatible. You can then save images from the Macintosh onto the
SD memory card and edit these images.

Inserting the SD memory card

# Insert the SD memory card into the PC

card adapter as shown in the illustration
at right.

Push the card in until it locks into place.
Make sure that it is facing the correct way.

Note:

B If the SD memory card is inserted into a Macintosh using the PC card

adapter while the write-protect switch is at the LOCK position, it will take a
long time (a few minutes depending on the case) for the Macintosh to
recognise the card, and an error message may appear. If this happens,
take the SD memory card out of the Macintosh by following the steps on
page

, and change the position of the write-protect switch so that it is

not at the LOCK position.

CARD

Eject button

CARD

PC card adapter

SD memory card