Planar C67RX User Manual

The optional VIM is shipped separately and installed on site. 

Always turn off power and remove the power cord when 

adding or removing an electronic part.

1 Attach a ground strap to your wrist and the chassis.

Failure to properly use a grounding strap can destroy sensi-

tive electronic components in the control board.

2 Loosen the screws on the 

back of the display that hold 
the control board in place.

3 Swing the control board to 

about 45° and lift it off its pin 
hinges. It will still be con-
nected to two or more 
cables at the bottom.

4 Bring the control board partly out the 

opening and disconnect all the cables.

5 Remove six screws from the sides of the 

covers.

6 Remove the DVI connector EMI shield. Use a 3/16" nut 

driver. The EMI plate may be stuck to some EMI tape. Try 
not to tear the tape.

7 Remove the cover of the control board. It is a snug fit.

1 Slide the VIM in its space and press it into its connector on 

the main control board.

2 Install nine screws to secure the board.
3 Replace the control board cover. Check first to see that all 

the LEDs are straight and none are bent over. Carefully lay 
the cover all the way down over the control board, watch-
ing the LEDs to see that they are visible through their 
holes.

4 Press the cover onto the control board; it is a snug fit.
5 Attach the cover using the 6 screws at the sides. 
6 Install the two nuts and washers in the top right corner.
7 Replace the EMI shield at the bottom with the 3/16" stand-

off nuts.

8 Reconnect any cables you may have removed.
9 Replace the control board in the display. The hinge is two 

pins on the display chassis and two holes on the control 
board. Fit the top hole first. That pin is a little longer.

10 It is now safe to replace the power cord and turn on the 

power. 

Connector