Panasonic TC-43P400H User Manual

Notes:
 • Main plug types vary between countries. The main plug shown at left may

therefore not be the type fitted to your set.

 • The On/Off switch on this model does not full disconnect the TV from the

mains supply.

Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.

The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the
batteries to burst.

Old Batteries

New Batteries

Replace both batteries at the same time.

Don't mix diffrent battery types.
(alkaline with carbon zinc, etc.)

Don't Recharge.

Power Switch

Power Indicator

Two “R6 (AA)” size

Notes:
 • When in the Stand-by condition (Refer to page 15), it is also possible to turn the TV set on by pressing  any of the

“Direct Programme Number Selection buttons” (0 - 9) or “Programme Number Up or Down buttons” on the TV set or
on the Remote Control.

 • If the Wall Outlet is switched OFF or the Main Plug is unplugged, when the TV set is again turned ON (by either

connecting the Main Plug to the Wall Outlet or switching the Wall Outlet ON), it will have returned to the original state.

Power OFF

Power ON

Push the Power switch on Television to turn the set on.

Power Indicator
No light: Power OFF condition

Power Indicator
No light: Normal viewing condition
Red      : Stand by

B a t t e r i e s :   U s e   t w o   “ R 6   ( A A ) ”   s i z e
batteries.
Insert the batteries ensuring the correct
polarities.
This is identifiable by the “+” and “

−

” symbols

on the batteries and inside the battery
compartment.

Open the cover.
Apply slight downward pressure
while pulling towards the bottom.

Note: Even when the Power Switch is "OFF", the TV set

will still consume a small amount of power.