Planar C50RX User Manual

1 Using two people, remove the screen from the packing 

case. Grab near the corners as you lift the screen from the 
packing case.

We suggest you save the screen packaging until the entire array 

is installed.

2 Cut open the protective envelope. Be careful not to 

scratch the screen or the frame.

Caution: The screen is heavy, delicate and expensive. Take care when 
handling.

3 Remove the screen from the envelope and carefully place 

it aside. Notice there are two slots in the back edge of the 
screen. The screen guide arms go into slots.

There is a label on the bottom of the screen.

4 Prepare the center unit in the bot-

tom row to receive a screen by pull-
ing the support rails all the way out.

5 Using two people, lift the 

screen at the sides. Hang 
the screen on the screen 
guide hooks. It is easier 
to do this one side at a 
time, with one person 
holding still, and the 
other person hanging 
the screen on the hook.

6 Press the heel of your hand against all four corners of the 

screen until the spring-loaded latches click into place.

You may have to lift the screen a little to get guide pins on the 

screen brackets to fit into the holes in the back of the screen.

Caution: Don’t hit the screen hard; it can break.

7 Continue installing screens from the center out until you 

have installed screens for an entire row.

8 Move to the next row up, and install a screen on the center 

unit.

9 Repeat steps 1 through 8 until all screens have been 

installed.

If the screens are not flat with 
each other, there is a z-axis 
adjustment screw at the top 
and bottom of the inside 
edge of the screen. You must 
open the screen to make this 
adjustment.

You can also make x-axis (left 
or right) and y-axis (up or 
down) adjustments at the top 
corners on both sides of the 
screen. These can be adjusted 
without opening the screen.

Pin in the 
slot in 
screen

Hook in 
screen 
arm

Y-axis

X-axis

Z-axis