Panasonic DW5100UL User Manual

55

If too much dust accumulates on the air filter, [CLEAN THE AIR FILTER]* appears at the lower left of the screen,
and the temperature monitor (TEMP) will blink once. If even more dust is allowed to accumulate, the temperature
inside the main unit will rise, the temperature monitor (TEMP) will blink twice, and the power is turned off.
Clean the air filter section once every 100 hours or so as a guideline depending on the location of projector
operation.
* It appears only for 30 seconds within 3 minutes after the power is turned on. It disappears if any of the buttons on

the rear side of the main unit or on the remote control is pressed.

Turn off the main power supply observing the procedure (Powering off the projector) on page 25 and then
remove the power plug.

There are two air filters, one at the left and one at the right.
Use your finger to pull the air filter tab toward you, and remove it from the main unit.

Set the air filter in the reverse order to step 

.

Suck off deposited dust with a vacuum cleaner.

• Do not to suck in the air filter itself.
• Do not rinse off the air filter with water.  Doing so will impair the filter’s ability to provide

protection from dust.

• Fit the air filters into place with the filter material facing the back.

(The left and right filters have the same shape.)

• The air filter must be fitted in place when using the projector.

Using the projector without the air filter fitted inside, dirt and dust are sucked into the projector,
causing failure.

• If cleaning cannot remove the dust completely, then it is a sign to replace the air filter. Consult the

dealer. In addition, when the lamp unit is replaced, also replace the air filter.

• Be absolutely sure to use the air filter specifically designed for use with the projector.

Air filter