Panasonic DW10000U User Manual
ENGLISH –
35
Basic Operation
Powering up the projector
# Connect the supplied power
cable. (120 V AC, 50 Hz/60 Hz)
$ Press the “ | ” marked side of the
MAIN POWER switch to turn on
the power.
the power.
The power indicator lamp on the projector will
flash in red. After a short period, the indicator
will illuminate and the projector will enter
standby mode.
flash in red. After a short period, the indicator
will illuminate and the projector will enter
standby mode.
% Press POWER ON “ | ”.
The power indicator lamp illuminates in green
and soon the image is projected on the screen.
and soon the image is projected on the screen.
Note
If the projector is powered up at about 0 °C, a
warm-up period of approximately 5 minutes may
be necessary to start projection. The temperature
monitor (TEMP) lamp lights up during the warm-up
period. When the warm-up is completed, the
temperature monitor (TEMP) lamp turns off and the
image is projected on the screen.
warm-up period of approximately 5 minutes may
be necessary to start projection. The temperature
monitor (TEMP) lamp lights up during the warm-up
period. When the warm-up is completed, the
temperature monitor (TEMP) lamp turns off and the
image is projected on the screen.
If the temperature of the operating environment is
low and warm-up takes more than 5 minutes, the
projector will judge that a problem has occurred
and the power will be turned off automatically. If
this happens, increase the temperature around the
projector so that it is 0 °C or higher, and then turn on
the MAIN POWER switch and the POWER ON “ | ”
switch once more.
low and warm-up takes more than 5 minutes, the
projector will judge that a problem has occurred
and the power will be turned off automatically. If
this happens, increase the temperature around the
projector so that it is 0 °C or higher, and then turn on
the MAIN POWER switch and the POWER ON “ | ”
switch once more.
•
•
•
•
# $
*
)
%
-
-, +-0
%
)
&, /
-
+
.
.
Making adjustment and
selection
selection
& Roughly adjust the focus of the
lens. (p. 37)
( Select and set the projection
scheme. (p. 76)
) Select the input signal by
pressing the input selector
button to toggle through RGB1,
RGB2, DVI-D, VIDEO, S-VIDEO
and AUX. (p. 43)
button to toggle through RGB1,
RGB2, DVI-D, VIDEO, S-VIDEO
and AUX. (p. 43)
The AUX button is disabled when an optional
input module is not connected.
input module is not connected.
* Adjust the tilt of the main unit in
front and rear or right and left.
(p. 20)
(p. 20)
+ Adjust the shift. (p. 37)
- Press AUTO SETUP if the input
- Press AUTO SETUP if the input
signal is RGB signal. (p. 44)
. Fit the image size to the screen
size. (p. 37)
/ Adjust the focus. (p. 37)
0 Display the zoom adjustment
0 Display the zoom adjustment
menu again and adjust the zoom
to fit the image size to the screen
size. (p. 37)
to fit the image size to the screen
size. (p. 37)
•
(
(