Sharp PG-A10S User Manual
58
1
2
3
User
service
screw
service
screw
Tab
Lamp
unit
unit
BQC-PGA10X//1
Removing and Installing
the Lamp Unit
the Lamp Unit
Info
• Be sure to remove the lamp unit using the
handle. Be sure not to touch the glass sur-
face of the lamp unit or the inside of the
projector.
face of the lamp unit or the inside of the
projector.
• To avoid injury to yourself and damage to
the lamp, be sure to carefully follow the
steps below.
steps below.
• Do not loosen other screws except for the
filter/lamp unit cover and lamp unit.
• Please refer to the installation manual in-
cluded with the lamp unit.
1
Press
on the projector to
turn off the power.
• Wait until the cooling fan stops.
Warning!
• Do not remove the lamp unit from the
projector right after use. The lamp will
be very hot and may cause burn or
injury.
be very hot and may cause burn or
injury.
2
Disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3
Change the air filter.
• Change the air filter whenever you in-
stall the lamp unit (see pages 53 and
54).
54).
4
Remove the filter/lamp unit
cover.
cover.
• Turn the projector over. Loosen the user
service screw (1) that secures the fil-
ter/lamp unit cover. Pressing the tab
(2), remove the filter/lamp unit cover
(3).
ter/lamp unit cover. Pressing the tab
(2), remove the filter/lamp unit cover
(3).
AC socket
Regarding the Lamp
Power OFF button
A10X_A10S#E_Print#p51_62.p65
03.2.4, 2:07 PM
58