Sim2 Multimedia NERO 3D-2 User Manual
Variable Iris (Nero 3D-2/3D HB)
This adjustement is available only on the Nero 3D-2 and Nero 3D HB.
This adjustement is available only on the Nero 3D-2 and Nero 3D HB.
Controls the iris in the the optical engine. Larger values increase brightness and smal-
ler values increase contrast in the projected image.
RGBS Sync
This setting indicates where the sync relative to the RGB signal is supplied. Choose:
ler values increase contrast in the projected image.
RGBS Sync
This setting indicates where the sync relative to the RGB signal is supplied. Choose:
•
HV when the HV connector is used for the RBGS sync signal
•
Video when the RGB sync signal originates from a SCART outlet (via the
SCART/R-G-B-sync conversion cable). In this case the R, G and B signals are
connected to the specific RCA connectors and the sync signal is connected to
connected to the specific RCA connectors and the sync signal is connected to
the Video input
3D Glasses
Selects the type of active shutter glasses you are using. Choose:
•
SIM2 (the default setting) when you are using the optional SIM2 Visus 3D
glasses and the SIM2 Visus 3D emitter
•
Universal if you are using the optional Universal glasses and the optional Uni-
versal 3D emitter. For more information refer to “
” on
Important:
Make sure the 3D glasses type is set correctly to achieve best synchroniza-
tion, stereo separation, and image quality.
Test Patterns
Enters internal test patterns, that are needed for installation or calibration purposes.
Test Patterns
Enters internal test patterns, that are needed for installation or calibration purposes.
Press ▴ or ▾ on the remote control or on the projector keypad to cycle through the
test patterns. To exit test patterns press Esc on the remote control or on the projector
test patterns. To exit test patterns press Esc on the remote control or on the projector
keypad.
Note:
OSD menus are not available while test patterns are displayed.
Initial Settings
Resets most projector settings to their factory presets. The settings in the following
Resets most projector settings to their factory presets. The settings in the following
list are not reset:
•
Serial Number and Model name
•
Lamp Hours
•
User Memories (including Memories Names)
•
Source List (including Source Names)
•
Orientation
•
Zoom and Focus
•
Y/C Delay
•
Position
Note:
Before performing this operation, a confirmation message appears. Press ▸ to
Confirm and continue with the reset or press ◂ to Cancel.
Menu
This menu section provides access to OSD adjustments.
4
Operation
Nero 3D
User Guide
30