Kathrein UFS 712si User Manual
9
CONNECTION AND SET-UP
The following section is intended specifi cally for specialist dealers. You only need to pay attention to this
section if you are carrying out the installation yourself.
section if you are carrying out the installation yourself.
The “Connection examples” section provides a sample confi guration.
Do not connect the unit to the mains until all installation work has been properly carried out. Refer to the
information in the “Safety instructions” section.
Do not connect the unit to the mains until all installation work has been properly carried out. Refer to the
information in the “Safety instructions” section.
Connect the Sat IF inputs on the receiver to the satellite reception system. Use
a coaxial cable with a standard F connector.
a coaxial cable with a standard F connector.
If the F standard connectors are not yet fi tted on the cable, strip the insulation from
the cable as shown in the following illustration and carefully twist the F standard
connectors on to the ends of the cables until they are securely seated.
the cable as shown in the following illustration and carefully twist the F standard
connectors on to the ends of the cables until they are securely seated.
When fi tting the connector, make sure that no wires from the braid are touching
the inner conductor, so no short circuit can occur.
the inner conductor, so no short circuit can occur.
The quality of the reception signal depends on the connection!
The presets for the control signals have been made for standard reception systems, i.e. 14/18 V for
polarity reversal and 22 kHz switching signal for low/high band changeover on multi-feed reception
systems.
polarity reversal and 22 kHz switching signal for low/high band changeover on multi-feed reception
systems.
CONNECTING THE UNIT (SAT-IF CONNECTIONS)
RECEPTION REQUIREMENTS
Make sure that your own satellite antenna system is equipped at least with
a universal LNB for digital reception in the high-band range.
a universal LNB for digital reception in the high-band range.
RECEPTION SYSTEM PRESETS