Kathrein UFS 740sw User Manual

Page of 88
3
The channels available on the satellites and transponders are subject to continual change. If changes do 
occur, the new channels have to be set in the receiver because the factory preset programming corresponds 
to the status on the date of manufacture. The information for these settings can be found on the Internet or 
in relevant magazines.
Your receiver is factory fi tted with the latest software version. We are, however, constantly working on 
adapting the software in response to the wishes of our customers and to developments in technology. 
The “Service Menu” section provides more information on this.
The information in this operating manual was correct at the time of going to press. 
We reserve the right however to make changes at any time and without prior notice. 
If new software is released for your receiver, and this affects the information in the operating manual 
(e.g. changes to the menus and/or functions), if we believe it necessary we will make available a new 
operating manual for download under “www.kathrein.de”.
Please keep the original packaging in case you need to return the product at any time!
If the product is not properly packed, the warranty claim is invalidated.
Make a note of the receiver‘s basic settings, so as to be able to restore them if necessary!
Make a note of the receiver's basic settings (these are set during the fi rst installation), so you can restore 
them if necessary!
The term DiSEqC™ used in this operating manual is a registered trade mark of the European 
Telecommunication Satellite Organisation (EUTELSAT).
IMPORTANT INFORMATION
SWITCHING OFF THE RECEIVER AND UPDATING THE EPG
By pressing the
 
 
button you can switch the receiver out of TV mode and into standby mode. Pressing any 
of the numeric buttons returns it from standby mode into operating mode.
Every night at 03:00 the receiver automatically starts to update the EPG data. This updates the EPG data 
for the fi rst 25 channels of the overall channel list. This update happens however only if the receiver is in 
standby mode. If the receiver is completely switched off (at the mains) or if it is in operation, the update will 
be delayed. The receiver will update the EPG data when it is next switched from operating mode into standby 
mode. After updating the data, the receiver automatically switches back to standby. You can however by 
pressing the
 
 
button break off the update before it is fi nished; the receiver then switches immediately into 
standby mode.
REFERENCE NOTE ON AUDIO MPEG INC. AND S.I.SV.EL, S.P.A:
This device employs legally protected technologies which are protected by patents in the USA as well as by 
intangible property laws in other countries. 
Audio MPEG Inc. and Societa‘ Italiana per lo sviluppo dell‘elettronica, S.I.SV.EL, S.P.A, have granted 
KATHREIN-Werke KG rights of use which are subject to certain restrictions. These restrictions must also be 
observed by you as a customer. 
According to these, this device is only to be used by end customers for private, non-commercial purposes 
and for licensed content. Use for commercial purposes is not authorised. Utilisation of products or procedures 
sold or used with this device are not comprehended. With reference to licensed technologies, application of 
reversible procedures as well as dismantling of the device are both not permitted.