Polycom DOC2702A User Manual
Chapter 2-Conference Profiles
Polycom, Inc.
2-7
AVC Conferencing Parameters
Basic Conferencing Parameters
When defining a new video Profile, you select the parameters that determine the video
display on the participant’s endpoint and the quality of the video. When defining a new
conference Profile, the system uses default values for Continuous Presence (CP) standard
conferencing. Continuous Presence conferencing enables several participants to be viewed
simultaneously and each connected endpoint uses its highest video, audio and data
capabilities up to the maximum line rate set for the conference.
The main parameters that define the quality of a video conference are:
•
display on the participant’s endpoint and the quality of the video. When defining a new
conference Profile, the system uses default values for Continuous Presence (CP) standard
conferencing. Continuous Presence conferencing enables several participants to be viewed
simultaneously and each connected endpoint uses its highest video, audio and data
capabilities up to the maximum line rate set for the conference.
The main parameters that define the quality of a video conference are:
•
Line (Bit) Rate - The transfer rate of video and audio streams. The higher the line (bit)
rate, the better the video quality.
rate, the better the video quality.
•
Audio Algorithm - The audio compression algorithm determines the quality of the
conference audio.
conference audio.
•
Video protocol, video format, frame rate, annexes, and interlaced video mode - These
parameters define the quality of the video images. The RMX will send video at the best
possible resolution supported by endpoints regardless of the resolution received from
the endpoints.
—
parameters define the quality of the video images. The RMX will send video at the best
possible resolution supported by endpoints regardless of the resolution received from
the endpoints.
—
When Sharpness is selected as the Video Quality setting in the Conference Profile, the
RMX will send 4CIF (H.263) at 15fps instead of CIF (H.264) at 30fps.
RMX will send 4CIF (H.263) at 15fps instead of CIF (H.264) at 30fps.
—
H.264 High Profile protocol provides better compression of video images in line
rates lower than 384 Kbps and it will be automatically selected for the endpoint if it
supports H.264 High Profile. If the endpoint does not support H.264 High Profile,
supports H.264 High Profile. If the endpoint does not support H.264 High Profile,
the RMX will try H.264 Base Profile which provides good compression of video
images in line rates lower than 384 Kbps (better than H.263 and not as good as
H.264 High Profile).
images in line rates lower than 384 Kbps (better than H.263 and not as good as
H.264 High Profile).
—
When working with RMXs at low bit rates (128, 256, or 384Kbps), HDX endpoints
will transmit SD15 resolution instead of 2CIF resolution.
will transmit SD15 resolution instead of 2CIF resolution.
When using a full screen (1x1) conference layout, the RMX transmits the same
resolution it receives from the endpoint.
•
Lost Packet Recovery (LPR) - LPR creates additional packets that contain recovery
information used to reconstruct packets that are lost during transmission.
2560
Video Switching
3072
3584
4096
6144
Not Supported
Video Switching
Table 2-3
Video Session Mode by Line Rate and Card type (Continued)
Line Rate (kbps)
MPM
MPM+
MPMx