Polycom DOC2702A User Manual

Appendix I-Polycom Open Collaboration Network (POCN)

Polycom, Inc.

For more information see "Procedure 4: Configuring a TIP Enabled Profile on the MCU” 

.

To configure the various Cisco entities the following procedures are required.
CUCM
1

Configure the CUCM to send and receive calls from the H.323 network.
a

With Neighbored IOS and CMA Gatekeepers
For more information see the Polycom Unified Communications Deployment Guide for 

Cisco Environments, “Configuring Cisco Unified Communications Manager for H.323”.

With CMA Gatekeeper
For more information see the Polycom Unified Communications Deployment Guide for 

Cisco Environments, “Configuring Cisco Unified Communications Manager for H.323”.

With IOS Gatekeeper
For more information see the Polycom Unified Communications Deployment Guide for 

Cisco Environments, “Configuring Cisco Unified Communications Manager for H.323”.

IOS Gatekeeper
>> Set up zones and gateway type prefixes to enable dialing to DMA and MCU systems.

For more information see the Polycom Unified Communications Deployment Guide for Cisco 

Environments, “Configuring the Cisco IOS Gatekeeper “.

IOS and CMA Gatekeepers (Neighbored)
>> Configure the Cisco IOS Gatekeeper for two separate zones.

For more information see the Polycom Unified Communications Deployment Guide for Cisco 

Environments, “Configure the Cisco IOS Gatekeeper for use with a CMA System”.

The following table lists the Polycom products supported within the various Deployment 

Architecture.
Only MCU configurations are described in detail in this document.
Configuration procedures for all other solution components are described in the Polycom 

Unified Communications Deployment Guide for Cisco Environments.

Polycom DMA 7000 system

V4.0

Polycom RealPresence Collaboration Server (RMX) 
2000 and RealPresence Collaboration Server (RMX) 
4000 systems

V7.6 and higher
MPMx card is required.