Pelco C1927M User Manual

26

Pelco Manual C1927M (5/99)

To program a camera input:

1.

Press the desired CAMERA button for approximately three seconds. Type the
password, if requested. The Camera menu appears. A video insert appears that shows
what the camera is viewing. This is useful to make sure you have selected the correct
camera and to see what effect there is on the video when you select a menu option.

2.

The currently selected menu item blinks.

3.

Use the arrow buttons to move between items on the screen.

4.

When the menu item you desire is highlighted (blinking), press the +/- button to cycle
through the options to select the one you want. Use the right arrow button to advance
to the next character position when titling a camera.

Set to 75 OHM when equipment is connected only to the video IN connector.

Set to LOOP HI-Z when equipment is connected to the video OUT (looping) connec-
tor. Equipment connected to the looping connector must be terminated at 75 ohms.

Refer to the 

Alarms

 section for an explanation of normally closed and normally open

operation.

EXTENDED - Use when your system has moveable cameras controlled by 32-bit
Coaxitron

®

 receivers, such as Esprit™, Intercept

®

, Spectra

®

, and LRD41C21/

LRD41C22 Series.

OFF - Use when your system has fixed cameras only.

STANDARD - Use when your system has moveable cameras controlled by 15-bit
Coaxitron

®

 receivers, such as the CX9000 Series, the PT7700, and the ED25/27/28/29.

Figure 15.  Basic Camera Menu

OPEN
CLOSED
DISABLED

VIDEO INPUT TERMINATION 75 OHM
ALARM INPUT NORMALLY

OPEN

COAXITRON FORMAT

EXTENDED

ACTIVITY DETECTION

ENABLED

SET DETECTION MASK

ENABLED
DISABLED

*

* ONLY NINE CHARACTERS APPEAR WHEN IN THE 16-CAMERA DISPLAY.

EXTENDED
OFF
STANDARD

(HYPHEN)