Avaya S8100 User Manual
1 Install and cable a G600 cabinet
Install and wire telephones and other equipment
104
S8100 Installation and Upgrades
November 2003
1
Before installing the DS1 Interface circuit pack, set the option switches as shown in
2
Install cross-connect jumpers to connect the pins from the digital trunk circuit pack to appropriate
pins on the external digital trunk.
pins on the external digital trunk.
3
Administer the DS1 Interface circuit pack on the DS1 and Trunk Group screens. See
Administrator’s Guide for Avaya Communication Manager (555-233-506).
Administrator’s Guide for Avaya Communication Manager (555-233-506).
Cable examples for tie trunk connectivity
DS1 tie trunks provide 1.544-Mbps (T1) or 2.048-Mbps (E1) digital data service between 2 collocated
systems or between the system and a data network. The following cables can be used:
systems or between the system and a data network. The following cables can be used:
•
C6C connector cable – 50-foot (15.2-m) shielded cable with a 50-pin male connector on 1 end
and a 15-pin male connector on the other end. Use to connect a DS1 Tie Trunk circuit pack to a
channel-service unit.
and a 15-pin male connector on the other end. Use to connect a DS1 Tie Trunk circuit pack to a
channel-service unit.
•
C6D connector cable – 50-foot (15.2-m) shielded cable with a 50-pin male connector on each
end. Use to connect DS1 tie trunks in collocated cabinets.
end. Use to connect DS1 tie trunks in collocated cabinets.
•
C6E connector cable – 100-foot (30.5-m) shielded cable with a 50-pin male connector on 1 end
and a 50-pin female connector on the other end. Use as an “extension” cable between the DS1 Tie
Trunk circuit pack and other connector cables.
and a 50-pin female connector on the other end. Use as an “extension” cable between the DS1 Tie
Trunk circuit pack and other connector cables.
•
C6F connector cable – 50-foot (15.2-m) shielded cable with a 50-pin male connector on 1 end
and a 3 inch (7.62-cm) stub on the other end. Use to connect the DS1 Tie Trunk circuit pack to
channel multiplexers requiring hardwired connections. See
and a 3 inch (7.62-cm) stub on the other end. Use to connect the DS1 Tie Trunk circuit pack to
channel multiplexers requiring hardwired connections. See
page 104 for a pinout.
Table 11: Pinout of C6F cable
Wire color
Lead designation
Pin number
White/Green
LI (high side)
47
Green
LI
22
White/Brown
LO
48
Brown
LO (high side)
23
White/Slate
LBACK2
49
Slate
LBACK1
24