ECS 945GCD-M 89-206-R15101 User Manual
Product codes
89-206-R15101
10
Installing the Motherboard
DDR2 SDRAM memory module table
Installing Memory Modules
This motherboard accommodates two memory module. It can support two 240-pin
DDR2 533. The total memory capacity is 4 GB.
DDR2 533. The total memory capacity is 4 GB.
Do not remove any memory module from its antistatic packaging
until you are ready to install it on the motherboard. Handle the
modules only by their edges. Do not touch the components or metal
parts. Always wear a grounding strap when you handle the modules.
until you are ready to install it on the motherboard. Handle the
modules only by their edges. Do not touch the components or metal
parts. Always wear a grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1
This motherboard supports unbuffered DDR2 SDRAM .
2
Push the latches on each side of the DIMM slot down.
3
Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
installed correctly.
4
Check that the cutouts on the DIMM module edge connector match the
notches in the DIMM slot.
5
Install the DIMM module into the slot and press it firmly down until it
seats correctly. The slot latches are levered upwards and latch on to
the edges of the DIMM.
the edges of the DIMM.
DDR2 533 266 MHz
Memory module
Memory Bus
Installing Hardware