Epson 3010 User Manual

Maintenance

After replacing the lamp, plug the projector back in and press the Ppower button on the 
projector or the 

On 

button on the remote control. Then follow these steps to reset the lamp 

usage timer:

1. Press the 

Menu

 button on the projector or remote control.

2. Use the menu navigation buttons to open the 

Reset

 menu, then select 

Reset Lamp 

Hours

. 

3. When you see a confirmation prompt, highlight 

Yes

 and press the 

Enter

 button.

4. When you’re finished, press the 

Menu

 button to exit.

The lamp usage timer shows 0H until you’ve used the lamp for at least 10 hours.

You can use the Info menu to view information about the current display settings and how 
long the projection lamp has been in use. To access the Info menu:

1. Press the 

Menu

 button on the projector or remote control.

2. Use the menu navigation buttons to open the 

Info

 menu. The following information 

appears:

Note: The information displayed depends on the currently selected image source. The Lamp 
Hours shows 0H until you’ve used the lamp for at least 10 hours.

The resolution indicates the total number of scan lines in the source signal. The number of visible 
scan lines depends on the signal format standard and selected display settings (see page 81).

■

Lamp Hours

■

3D Format

■

Source

■

Sync Info

■

Input Signal

■

Video Signal

■

Resolution

■

Deep Color (color depth)

■

Scan Mode

■

Status (error information)

■

Refresh Rate

■

Serial Number

pl3010_3010e_UG.book  Page 67  Wednesday, September 7, 2011  6:28 PM