Epson 3010E User Manual

Making Detailed Adjustments

3. Do one of the following:

■

Select 

Reset Lamp Hours 

to clear the lamp usage timer and reset it to zero. 

You should reset the lamp timer only when you install a new projector lamp. See 
page 67 for more information.

■

Select 

Reset Memory

 to clear all memory settings.

■

Select 

Reset All 

to return all projector settings to their original defaults (except Input 

Signal, User Button, Language, and Lamp Hours).

Use the settings in this section to adjust the image size and position, suppress on-screen text, 
and select basic setup options.

Before adjusting any of these settings, make sure you have already selected an appropriate 
aspect ratio for the type of picture you’re viewing (see page 27). 

■ Overscan

For component and HDMI video formats, this setting lets you see the edges of the image 
that are not normally visible in the picture (see page 81). If you see interference when you 
set 

Overscan

 to 

Off

, try adjusting the 

Position

 as described below. 

Note: The Auto setting is only available when the input source is HDMI1, HDMI2, or 
WirelessHD.

■ Position

Note: This setting cannot be used with a signal input through the HDMI 1 or HMDI 2 port or 
the WirelessHD connection (PowerLite Home Cinema 3010e only).

Use the arrow buttons to fine-tune the position of the image on the screen.

Signal > Advanced > Overscan

Signal > Position

pl3010_3010e_UG.book  Page 52  Wednesday, September 7, 2011  6:28 PM