Fujitronic UG520H-x User Manual

Switch to be used

 in emergency

Emergency

Stop

UG320/220

UG221 

UG520/420

Screw

Type

Screw Size

M3

M4

M4

Torque (N•m)

0.3 to 0.5

0.3 to 0.5

0.5 to 0.7

Alcohol

BENZINE

BENZINE

Lock !

3. Never install POD in the same compartment as

high-voltage equipment.  The unit should be at

least 200 mm away from high-voltage lines or

power cables.

1. An emergency stop circuit must be composed of

an external relay circuit with a start signal for

POD built in.  Do not create switches on POD to

be used in case of emergency.

2. POD has a glass screen.  Never drop or subject

the unit to strong impacts.

3. Tighten mounting screws with the following

torques.

Note :Never fasten these screws too tightly,

otherwise the cover of POD may be deformed.

4. Securely fasten and lock every connector for

each cable.  Double-check this before turning the

power on.

5. In a dry environment, POD may generate a large

amount of static electricity.

Therefore, before touching the unit, touch a

grounded metallic section to discharge the static

electricity.

6. Application of thinner may discolor POD.  Use

alcohol or benzine available commercially for

cleaning.

7. Never remove any printed circuit board from

POD.  (This will harm the unit.)

8. Never operate the display by using a tool with a

sharp point like a screwdriver.

Touch the display by fingers.

2 Notes on Usage