ICOM IC-208H Instruction Manual

41

7

SCAN OPERATION

■ Scan start/stop

D Preparation

Scan resume condition (p. 45); program the scan edges
(pgs. 42, 43); program 2 or more memory channels (pgs. 27,
28); set skip settings (p. 44), if desired.

D Operation

q Select VFO mode for full/programmed scan with

[V/MHz•SCAN]; or memory mode for memory scan with
[M/CALL•PRIO].

• Select the desired bank for bank scan.

w Set the squelch to the point where noise is just muted.
e Push [V/MHz•SCAN] for 1 sec. to start the scan.

• To change the scanning direction, rotate [DIAL].
• The memory channel readout blinks the scan type as follows:

r Push [SET•LOCK] to switch full and programmed scan

(P1, P2, P3, P4 and P5), if VFO is selected in step q.

t To stop the scan, push [V/MHz•SCAN].

z Push [VFO/LOCK] to select VFO mode for

full/programmed scan; push [MR/CALL] to select
memory mode for memory scan.

• Push [FUNC] then [

MONI

1(BANK)] to select a bank

for bank scan.

x Push [

SQL

Y

D(MUTE)] or [

SQL

Z

#(16KEY-L)] to

set the squelch to the point where noise is just
muted.

c Push [

SCAN

2(T-SCAN)] to start the scan.

• Push [Y] or [Z] for 1 sec. also starts the scan.

v Push [

SET

B(D-OFF)] to switch full and pro-

grammed scan (P1, P2, P3, P4 and P5), if VFO
is selected in step z.

b To stop the scan push [

SCAN

2(T-SCAN)] or

[

CLR

A(MW)].

SCAN

2

SET

B

• During full scan

Indicates scan edge channels.
• P1 stands for 1A/1B
• P1 to P5 are available when they 

are programmed, and switches 
with [SET•LOCK].

Indicates bank initial.

Push [SET•LOCK] to select 
“ALL” (full) or programmed scan 
(P1, P2, P3, P4 and P5) in se-
quence.