Skylink ML-100 User Manual

Enter master

3 beeps for valid

password to

password. 1 long

programming mode

beep for invalid
password.

[1] - Master password
[2] - Secondary password
[3] - Duress password

Select any 4-digit pass-
word, each digit can be
from 0 to 9

Enter the new password

3 beeps if new  pass-

again for confirmation

word is accepted. You
will  hear  [Password
Accepted]

Master Password 

can be used for programming, arming, disarming the

system, and telephone access.  The default Master Password is [1234].

Secondary Password 

can be used for arming, disarming the system, and

telephone access.  Secondary Password cannot be used for programming.
The default Secondary Password is [0000].

 is used when you are forcibly compelled to disarm the

control panel. Entering the duress password will stop the siren from sounding
but the control panel will silently call the emergency phone numbers for help.
The default Duress Password is [3838].  You should definitely change this
password and let all the users know this password.

It is strongly recommended to change all 3 passwords when you first set
up the system.

[PROG]

[MPIN]

[2]

[1] or
[2] or
[3]

[new
4-digit
password]

[new
4-digit
password]

Enter
Programming
mode

Select
password
programming

Select which
password to
change

Enter new
password

Enter new
password to
confirm

1

2

3

4

5

–

9

–

Step

Keys

Function

Description

Note

After mounting the door sensor, it

- Please ensure the magnet is aligned with

doesn’t work anymore.

  the red marking on the transmitter.
- If you are mounting the sensor on to a
  metal  door or window, a spacer may be
  required  to avoid magnetic interference
  caused by the metal door / window.
-  Make sure the sensor is within the operation
  range of the control panel by bringing it
  closer to the control panel.

My motion sensor is not very

The motion sensor is designed to detect the

responsive, sometimes when I walk

“First Motion”.  First Motion means no motion

by it, the control panel doesn’t respond,

is detected within the past 20 seconds,

but sometimes it does.

and if a motion is then detected, that is the
“First Motion”.  So if you continue to walk
in front of the motion sensor, it will only
pick up the first motion.  Unless you wait
for 20 seconds, then walk again, the control
panel will respond.  Otherwise, the control
will only respond to the first motion.

When a sensor is triggered, the

- Make sure the battery in the sensor is

control panel doesn’t respond at all,

  installed properly, pay attention to the

what is the problem?

  polarity.
- Make sure the sensor is learned to the
  control panel.  Follow instructions on
  page 37 on how to learn a sensor.
- You may try to bring the sensor closer to
  the control panel, ensure it is not out of
  the operation range.

My motion sensor sometimes gets

Ensure the motion sensor is not facing

triggered by itself, how can I prevent

direct sunlight, nor any A/C or furnace

that?

vents.  You may also reduce the sensitivity
to low.  If your motion sensor is located
outdoors, you may want to relocate it.

–

48

–